Using Options / Using the Automatic Document Feeder

Loading Documents in the Automatic Document Feeder

Loading documents manually

Your Automatic Document Feeder can automatically load up to 100 sheets. See Document Specifications for further information.

Follow the steps below to load documents in the Automatic Document Feeder.

Slide the right edge guides all the way to the right.

Insert a stack of documents face up in the Automatic Document Feeder until it meets resistance, and then move the right edge guide so it is flush with the right edge of your documents.

Note:

Be sure to insert documents face up.

If you load multiple pages in the Automatic Document Feeder, the pages will be fed from the top and then ejected face-down.

To automatically scan both sides of a document, choose the Double-sided setting in EPSON Scan.

Make sure the switch on the lower left corner of the underside of the Automatic Document Feeder is set towards the circular mark, as shown below.

To proceed to scan the loaded documents, see Using the Automatic Document Feeder to Scan for details.

Loading documents manually

You can load documents manually even when the Automatic Document Feeder is installed.

To load a document manually, lift the Automatic Document Feeder and place the document on the document table. Then lower the Automatic Document Feeder and scan the document.

Note:

Opening the Automatic Document Feeder while scanning is in progress will result in an option error and may result in a paper feeding error.

Always close the Automatic Document Feeder and the middle cover before scanning or using the feeder.

[Top]

Previous

Next