Maintenance and Troubleshooting / Problems and Solutions

Error Indicators

Command error
Interface error
Fatal error
Option error

When an error occurs, the scanner stops operating and the ERROR and READY lights indicate the error type as described below.

ERROR Light	READY Light	Error Type
On	On	Command error
Flashing	Off	Interface error
Flashing	Flashing	Fatal error
Off	Off	Option error

Command error

The scanner has received incorrect commands from your scanning software.

When this error occurs, try to rescan the document. The scanner returns to normal when it receives correct commands. Normally you do not need to reset the scanner when this type of error occurs.

[Top]

Interface error

The interface setup is wrong or the scanner is not properly connected to the printer.

When this error occurs, check the interface connection and then push the operate button to turn the scanner off and then back on again to reset it.

[Top]

Fatal error

This type of error indicates one of the following problems:

The fluorescent lamp needs to be replaced.

The transportation lock lever is not released.

The scanner is malfunctioning.

Check that the transportation lock lever is released and check any installed options for problems. Next, turn the scanner off and then back on again. If this does not correct the problem, consult your dealer.

[Top]

Option error

This indicates a problem with an installed option, such as a paper jam, an empty document feeder, or an open cover.

Check the option and correct the cause of the problem.

[Top]