Safety Instructions

Read all these instructions and save them for later reference. Follow all warnings and instructions marked on the scanner.

• Unplug the scanner before cleaning. Clean with a damp cloth only. Do not spill liquid on the scanner.

• Do not place the scanner on an unstable surface, or near a radiator or heat source.

• Use only the power cord that comes with this product. Use of another cord may result in fire or electric shock.

• This product's power cord is for use with this product only. Use with other equipment may result in fire or electric shock.

• Use only the type of power source indicated on the scanner's label and always supply power directly from a standard domestic electric outlet with the AC power cord that meets the relevant local safety standards.

• Connect all equipment to properly grounded power outlets. Avoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on and off.

• Do not allow the power cord become damaged or frayed.

• If you use an extension cord with the scanner, make sure the total ampere rating of the devices plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure the total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's ampere rating.

• Except as specifically explained in this Online Reference Guide and the Setup Guide, do not attempt to service the scanner yourself.

• Unplug the scanner and refer servicing to qualified service personnel under the following conditions:

• If the power cord or plug is damaged.

• If liquid has entered the scanner.

• If the scanner has been dropped or the case damaged.

• If the scanner does not operate normally or exhibits a distinct change in performance. (Do not adjust controls that are not covered by the operating instructions.)

• If you plan to use the scanner in Germany, observe the following:

To provide adequate short-circuit protection and over-current protection for this scanner, the building installation must be protected by a 10 or 16 Amp circuit breaker.

Note for German-speaking users:

Bei Anschluss des Scanners an die Stromversorgung muss sichergestellt werden, dass die Gebäudeinstallation mit einer 10A- oder 16 A-Sicherung abgesichert ist.

Information for United Kingdom Users

Use of options

EPSON (UK) Limited shall not be liable against any damages or problems arising from the use of any options or consumable products other than those designated as Original EPSON Products or EPSON Approved Products by EPSON (UK) Limited.

Safety information

Warning:

Refer to the rating plate for the voltage and check that the appliance voltage corresponds to the supply voltage. Important: The wires in the mains lead fitted to this appliance are coloured in accordance with the following code: Blue — Neutral Brown — Live

If you have to fit a plug:
As the colours of the mains lead of this appliance may not match the coloured markings used to identify the terminals in a plug, please observe the following:

• The blue wire must be connected to the terminal in the plug marked with the letter N.

• The brown wire must be connected to the terminal in the plug marked with the letter L.

• If the plug is damaged, replace the cord set or consult a qualified electrician.

• Replace fuses only with fuses of the correct size and rating.

Warnings, Cautions, and Notes

Warnings

must be followed carefully to avoid bodily injury.

Cautions

must be observed to avoid damage to your equipment.

Notes

contain important information and useful tips on the operation of this product.