EPSON

Cleaning the Product

Cleaning the exterior of the product

To keep your product operating at its best, clean it thoroughly several times a year by using the following instructions.
Caution
Never use alcohol or thinner to clean the product. These chemicals can damage the product.
Use a soft, dry, clean cloth to clean the touchpad. Do not use liquid or chemical cleaners.
Use a soft, dry, clean cloth to clean the glass surface of the document glass. If the glass surface is stained with grease or some other hard-to-remove material, use a small amount of glass cleaner and a soft cloth to remove it. Wipe off all remaining liquid.
Do not press the glass surface of the document glass with any force.
Be careful not to scratch or damage the surface of the document glass, and do not use a hard or abrasive brush to clean it. A damaged glass surface can decrease the scan quality.
Note:
Close the paper support and the output tray when you are not using the product to protect the product from dust.

Cleaning the interior of the product

To keep your printouts at their best, clean the roller inside by using the following procedure.
Warning:
Be careful not to touch the parts inside the product.
Caution:
Be careful to keep water away from the electronic components.
Do not spray the inside of the product with lubricants.
Unsuitable oils can damage the mechanism. Contact your dealer or a qualified service person if lubrication is needed.
Load several sheets of A4-size plain paper.
Enter Copy mode from the Home menu.
Press to make a copy without placing a document on the document glass.
Repeat step 3 until the paper is not smeared with ink.