epson

The Printer Does Not Print

The printer status is indicated by an LCD screen for the SX400/TX400 Series, and by lights for the SX200/TX200 Series.

The LCD screen or all lights are off

Press the  On button to make sure the printer is on.
Turn off the printer and make sure that the power cord is securely plugged in.
Make sure that your outlet works and is not controlled by a wall switch or timer.

The LCD screen or lights came on and then went out

The printer’s voltage may not match the outlet rating. Turn off the printer and unplug it immediately. Then check the label on the back of the printer.
Caution:
If the voltage does not match, DO NOT PLUG YOUR PRINTER BACK IN. Contact your dealer.

The LCD screen or lights are on

Turn off the printer and computer. Make sure the printer’s interface cable is securely plugged in.
If you are using the USB interface, make sure your cable meets the USB 1.1 or 2.0 standards.
Turn off the printer and the computer, disconnect the printer’s interface cable, then print an operation check page.
See Running a printer operation check (SX400/TX400 Series)
See Running a printer operation check (SX200/TX200 Series)

If the check page prints correctly, make sure the printer driver and your application are installed correctly.
If you are trying to print a large image, your computer may not have enough memory. Try reducing the resolution of your image or printing the image at a smaller size. You may need to install more memory in your computer.
Uninstall the printer driver, then reinstall it.
See Uninstalling the Printer Software

An ink error is indicated after you replace the cartridge

Make sure the ink cartridge holder is at the ink cartridge replacement position.
Note:
If the ink cartridge holder is at the far right position, do one of the following to move it to the ink cartridge replacement position.
SX400/TX400
Press the  [Setup] button, select Maintenance, and then select Change Ink Cartridge.
SX200/TX200
Press the  Stop button.
Remove and reinsert the ink cartridge and then continue with the ink cartridge installation.

All lights are off

Press the  power button to make sure the printer is on.
Turn off the printer and make sure that the power cord is securely plugged in.
Make sure that your outlet works and is not controlled by a wall switch or timer.