 |
 |
|
||
 |
||||
Loading Envelopes
Follow these steps to load envelopes.
Note:|
The thickness of envelopes and their ability to fold vary widely. If the total thickness of the stack of envelopes exceeds 10 mm, press down the envelopes to flatten them before loading. If print quality declines when stack of envelopes is loaded, load one envelope at a time.
You can load up to 10 envelopes at a time in the rear feeder.
Do not use envelopes that are curled or folded.
Flatten the envelope flaps before loading.
Flatten the leading edge of the envelope before loading.
Avoid using envelopes that are too thin, as they may curl during printing.
|
 |
Open and extend the paper support.
|
 |
Slide the edge guide.
|
 |
Load envelopes short edge first with the flap facing down and to the left.
|
 |
Slide the left edge guide against the left edge of the envelopes, but not tightly.
|
 |
Open and extend the output tray.
|
