 |
 |
|
||
 |
||||
Cleaning the Product
Cleaning the exterior of the product
To keep your product operating at its best, clean it thoroughly several times a year by using the following instructions.
Caution|
Never use alcohol or thinner to clean the product. These chemicals can damage the product.
|
Use a soft, dry, clean cloth to clean the touch panel/touchpad. Do not use liquid or chemical cleaners.
Use a soft, dry, clean cloth to clean the glass surface of the document glass. If the glass surface is stained with grease or some other hard-to-remove material, use a small amount of glass cleaner and a soft cloth to remove it. Wipe off all remaining liquid.
Open the ADF cover and use a soft, dry, clean cloth to clean the roller and the interior of the ADF.
Do not press the glass surface of the document glass with any force.
Be careful not to scratch or damage the surface of the document glass, and do not use a hard or abrasive brush to clean it. A damaged glass surface can decrease the scan quality.
Note for the PX730WD/Artisan 730:|
Close the output tray and the front cover when you are not using the printer to protect the printer from dust.
|
Note for the PX830FWD/Artisan 837:|
Close the ADF paper support when you are not using the printer to protect the printer from dust.
|
Cleaning the interior of the product
To keep your printouts at their best, clean the roller inside by using the following procedure.
Warning:|
Be careful not to touch the parts inside the product.
|
Caution:|
Be careful to keep water away from the electronic components.
Do not spray the inside of the product with lubricants.
Unsuitable oils can damage the mechanism. Contact your dealer or a qualified service person if lubrication is needed.
|
 |
Load several sheets of A4-size plain paper.
|
 |
Enter Copy mode from the Home menu.
|
 |
Press
 to make a copy without placing a document on the document glass. |
 |
Repeat step 3 until the paper is not smeared with ink.
|