epson

Monitoring the Network Status

The network communication status is indicated via LEDs on printers that do not have an LCD panel.

LED lights and buttons

a:
Network status light (orange)
b:
Network status light (green)
Status
Indication
Wireless
Wired
Warming up
(orange) (green)
Flashing alternately
Disconnected
(orange) (green)
Connected
(orange) (green)
(orange) (green)
Connecting to network
(orange) (green)
(orange) (green)
Wireless auto setup in progress
(orange) (green)
Flashing alternately
PIN: Flashing at the same time
-
Wireless auto setup completed
(orange) (green) *1
-
Wireless auto setup error
(orange) (green)
-
Wireless auto setup error
(No IP address set)
 (orange)  (green) *1
-
= off, = on, = flashing
*1 The Network status light (orange) turns off after five minutes.
Network Buttons
WiFi
Press and hold for three seconds to make easy wireless LAN settings.
Press to release an easy wireless LAN setting error.
Press and hold for about 10 seconds to initialize network settings.
Press to print a network status sheet.
WiFi +
While holding down the WiFi button, press and hold the button for about three seconds to make easy wireless LAN settings in WPS PIN mode.

Printing status sheet

To confirm the network connection, print a status sheet using the following procedure.
Load a plain paper into the sheet feeder.
Press to print the status sheet.