While the Multi Photo Feeder is connected, you cannot scan using the document table. To scan using the document table, follow these steps to remove the Multi Photo Feeder and install the scanner cover:

Unplug the scanner’s power cord to turn it off.

Disconnect the Multi Photo Feeder cable from the scanner’s OPTION port.

Lift the Multi Photo Feeder straight up and off of the scanner.

Place the Multi Photo Feeder in its stand as shown below.

Note:

Do not let the plastic triangle on the paper path guide touch the stand.

Replace the scanner cover as shown below.

Close the scanner cover.

Connect the cover cable to the scanner’s OPTION port.