epson

Replacing the Roller Assembly Kit

You need to replace the parts on the roller assembly kit after scanning every 100,000 times.
Removal part
Part number
Number of scanning
Roller Assembly Kit
B12B813421
100,000
To replace the roller assembly kit, follow the steps below.
Turn off the scanner.
Remove all paper from the input tray.
Unplug the AC adapter from the scanner.
Pull the cover open lever and open the scanner cover.
Press the hook on the separation pad, then remove the installed separation pad.
Caution:
Do not touch the pick spring. Hold the separation pad holder as shown below.
Insert the bottom side of the new separation pad first, then press the hook on the separation pad to attach to the correct position.
Press the hook on both sides of the paper feed roller cover, then open the cover.
Slide and remove the installed paper feed roller.
Caution:
Do not touch the surface of the paper feed roller. Hold the paper feed roller as shown below.
Attach the new paper feed roller to the correct position.
Caution:
Do not install the paper feed roller in reverse direction.
Close the cover of the paper feed roller, then close the scanner cover.
Turn on the scanner.
Start EPSON Scan Settings. Then, click Maintenance.
Click Reset on the right of the Number of Scans.
Click OK.