Using Options / Using the Network Image Express Card
Connecting to Your Computer
Follow the step below to connect the Network Image Express Card to your computer.
 |
Connect an Ethernet cable (Category 5 shielded twisted-pair cable) to the RJ-45 connector on the Network Image Express Card, and then connect its other end to the network.
|
 |  |
Caution:
|
| | -
You must use a Category 5 shielded twisted-pair cable to connect the Network Image Express Card to prevent malfunction.
|
|
| | -
Do not connect or disconnect the network cable when the scanner is turned on.
|
|
| | -
Do not connect the Network Image Express Card and the computer directly. Connect the Network Image Express Card to the network by using a HUB.
|
|
 |
Turn on the scanner.
|
 |
Check the lights on the Network Image Express Card. Initialization is in progress while the red status light and the green data light are on. When the yellow status light goes on, initialization is complete.
|
[Top]
