Home
Printing : Home > Troubleshooting
The Printer Does Not Print

All lights are off
Lights came on and then went out
Only the On light is on
The error light is flashing or on
Print Head Carriage Problem

All lights are off
  • Press the On button to make sure the printer is on.

  • Turn off the printer and make sure that the power cord is securely plugged in.

  • Make sure that your outlet works and is not controlled by a wall switch or timer.

Top
Lights came on and then went out

The printer’s voltage may not match the outlet rating. Turn off the printer and unplug it immediately. Then check the label on the back of the printer.


Caution:

If the voltage does not match, DO NOT PLUG YOUR PRINTER BACK IN. Contact your dealer.

Top
Only the On light is on
  • Turn off the printer and computer. Make sure the printer’s interface cable is securely plugged in.

  • If you are using the USB interface, make sure your cable meets the USB 1.1 or 2.0 standards.

  • Make sure there is no packing material in the printer.

    If the check page prints correctly, make sure the printer software and your application are installed correctly.

  • If you are trying to print a large image, your computer may not have enough memory. Try reducing the resolution of your image or printing the image at a smaller size. You may need to install more memory in your computer.

  • Users of Windows Me and 98 can clear any stalled print jobs from the spool manager.
    See Canceling Printing

  • If the printer sounds like it is trying to print, but is unable to, run the Head Cleaning utility.
    See Cleaning the Print Head

Top
The error light is flashing or on
  • Check EPSON Status Monitor 3 (Windows) or EPSON StatusMonitor (Macintosh) to find the cause of the error, then try one or more of these solutions:

Top
Print Head Carriage Problem

If the carriage cover does not close or the print head carriage does not move to its home position, open the carriage cover and push the ink cartridges down until they click into place.

Top