This section provides instructions on how to load paper in the sheet feeder.

Open the paper support, then slide out the extension, and then open the feeder guard.

Lower the output tray and slide out the extension.

Slide out the left edge guide so that the distance between the two edge guides is slightly wider than the paper you are going to load.

Load the paper with the printable side up so it is against the right edge guide, and slide it into the sheet feeder.

Slide the left edge guide so that it meets the left edge of the paper.

Note:

Leave enough space in front of the printer for the paper to be fully ejected. Always load paper into the sheet feeder short edge first, even when you are printing landscape-oriented pictures. Make sure that the paper stack is flush with or lower than the  arrow mark on the edge guide.

Set the feeder guard back.