 |
 |
|
||
 |
||||
Transporting the Printer
If you move the printer some distance, you need to prepare it for transportation in its original box or one of a similar size.
Caution:|
When storing or transporting the printer, avoid tilting it, placing it vertically, or turning it upside down; otherwise ink may leak.
Leave the ink cartridges installed. Removing the cartridges can dry out the print head and may prevent the printer from printing.
|
Note:|
The illustrations in this section show the BX625FWD/SX620FW/960FWD/WorkForce 630/WorkForce 633.
|
 |
Make sure the printer is off.
|
 |
Open the scanner unit and make sure the print head is in the home position on the right.
|
Note:|
If the print head is not in the home position on the right, turn on the printer and wait until the print head locks in the far right position. Then turn off the printer.
|
 |
Close the scanner unit.
|
 |
Unplug the power cord from the outlet, then disconnect the USB cable from your computer. Disconnect all other cables from the printer.
|
 |
Close the output tray.
|
 |
Pull the release lever on the rear of the control panel and then lower the control panel to store.
|
 |
Remove all paper from the paper cassette and re-insert the cassette into the printer.
|
 |
Repack the printer in the box, using the protective materials that came with it.
|
Keep the printer level as you transport it. If you notice a decline in print quality, run a cleaning cycle or align the print head. For instructions, see the Printing Guide.