 |
 |
|
||
 |
||||
Loading Envelopes
Follow these steps to load envelopes:
Note:|
The illustrations in this section show the BX625FWD/SX620FW/960FWD/WorkForce 630/WorkForce 633.
|
 |
Pull out the paper cassette.
|
Note:|
If the output tray has been ejected, close it before pulling out the paper cassette.
 |
 |
Slide the edge guides to the sides of the paper cassette.
|
 |
Load envelopes lengthwise with the flap facing up.
|
Note:|
Make sure the number of envelopes does not exceed the limit specified for the type of media you are using.
|
 |
Slide the edge guides to the edges of the envelopes and check that the envelopes are not sticking out from the end of the cassette.
|
Note:|
Even if you do not feel a click, slide the edge guides to the edges of the envelopes.
|
 |
Keep the cassette flat and insert it back into the printer carefully and slowly.
|
 |
Slide out the output tray and raise the stopper.
|
Note:|
The thickness of envelopes and their ability to fold vary widely. If the total thickness of the stack of envelopes exceeds 10mm, press down on the envelopes to flatten them before loading. If print quality declines when a stack of envelopes is loaded, load one envelope at a time.
Do not use envelopes that are curled or folded.
Flatten the envelope flaps before loading.
Flatten the leading edge of the envelope before loading.
Avoid using envelopes that are too thin, as they may curl during printing.
Align the edges of the envelopes before loading.
|
For printing instructions, see the following instructions.