epson

Diagnosing the Problem

Troubleshooting printer problems is best handled in two steps: first diagnose the problem, then apply likely solutions until the problem is fixed.
The information that you need to diagnose and solve most common problems is provided by online problem solving, the control panel, the EPSON Status Monitor utility, or by running a printer operation check. Refer to the appropriate section below.
If you have a specific problem relating to print quality, a printout problem not related to print quality, or a paper feeding problem, or if the printer does not print at all, refer to the appropriate section.
To solve a problem, you may need to cancel printing.

Error indicators

You can identify many common printer problems using the lights on your printer. If the printer stops working and the lights are on or flashing, use the following table to diagnose the problem, then follow the recommended corrective measures.
Lights
Problem and solution
Paper out
No paper is loaded.
Load paper into the sheet feeder, and then press the  paper button. The printer resumes printing and the light goes out.
Double-paper feed
Two sheets of paper are fed at the same time.
Press the  button to feed and eject the paper. If the paper remains in the printer, see The paper jams.
Paper jam
Paper has jammed in the printer.
Ink expended
An ink cartridge is expended or not installed.
Replace the ink cartridge with a new one. If the light is still on after you have replaced the cartridge, it may not be installed correctly. Reinstall the ink cartridge so that it clicks into place.
See Replacing an Expended Ink Cartridge
Wrong cartridge
The currently installed ink cartridge cannot be used with the printer.
Replace the incompatible cartridge with an appropriate ink cartridge.
See Replacing an Ink Cartridge Before It Is Expended
Incorrectly installed ink cartridge
An ink cartridge is not installed correctly.
Ink low
An ink cartridge is nearly expended.
Obtain a replacement ink cartridge. To determine which cartridge is nearly expended, check the ink cartridge status.
See Checking the Ink Cartridge Status
Cover open
The printer cover is open.
Close the printer cover.
Flashing alternately
Maintenance
The printer's ink pads are saturated.
Contact Epson support to replace ink pads.
Unknown printer error
An unknown printer error has occurred.
Turn off the printer. Open the printer cover and remove any paper or other obstructions from the paper path.
Then turn the printer back on. If the error does not clear, contact your dealer.
= on, = off, = flashing slowly, flashing fast

EPSON Status Monitor (for Windows only)

If a problem occurs while printing, an error message will appear in the Status Monitor window.
When you need to replace an ink cartridge, click the How To button on the window, and EPSON Status Monitor will lead you step-by-step through the cartridge replacement procedure.
If an error message appears indicating the printer's ink pads are nearing the end of their service life, contact Epson support to replace them. When the printer's ink pads are saturated, the printer stops and Epson support is required to continue printing.

Running a printer operation check

If you are unable to determine the source of the problem, run a printer operation check to help you determine whether the problem comes from the printer or your computer.
To run a printer operation check, follow these steps.
Make sure both the printer and computer are turned off.
Disconnect the cable from the interface connector of the printer.
Make sure that A4 size paper is loaded in the sheet feeder.
Hold down the  paper button and press the  power button to turn on the printer. When the printer turns on, release both the buttons.
A test page prints showing a nozzle check pattern. If the pattern has gaps, you need to clean the print head.
If the test page prints, the problem probably lies in your software settings, the cable, or your computer. It is also possible that your software may not be installed correctly. Try uninstalling your software and reinstalling it.
See Uninstalling the Printer Software
If the test page does not print, you may have a problem with your printer. Try the suggestions in the following section.
See The Printer Does Not Print