How to select different languages, change the paper length and switch the line feed on / off on LX-300+ dot matrix printer?
Listed below are various details:

Follow the steps below to enter the default setting mode and change the printer’s default settings

1. Make sure paper is loaded and the printer is turned off
(Whenever you turn off the printer, wait at least 5 seconds before turning it back on; otherwise you may damage the printer)
2. While holding down the Tear Off button, turn on the printer. The printer enters the default setting mode and prints the language selection instructions
3. If you need to select a different language, press the LF/FF button until the Tear Off lights indicate the language you want, as described in the language selection instructions.
4. Press the Tear Off button to confirm your language selection and print the current default settings.
5. If you want to change any of the default settings, press the Tear Off button to print the instructions (three pages) in the language you selected.

When you finish, turn off the printer to exit the default setting mode. The current settings remain in effect until you change them again.

What is the exact set-up for the Dipswitches?

If you need to change the settings on your printer than you don’t need to change Dipswitches. The LX-300+ has built-in default settings that can be changed by using the front panel buttons.

Article: KB020054 Language: English Product Range: Dot Matrix

Save as PDF